1、Clean the pod and mod connection part method.

Regularly use a dry cotton swab or a slightly moistened cotton swab to clean the connection points between the Mod and the POD base, clean the mositure.

If there is too much mositure remaining, it may block the airflow holes and make it impossible to vape.

2、What are the steps to use pod to vape?

When a new coil is installed,let it sit for 3 minutes after filled with e-liquid before vaping.The first few puffs require a bit harder inhale, then you only need to vape normally.

3、How to use the rubber plug.

After filling pod with e-liquid, make sure the rubber plug is installed correctly. If there is warp, make sure it's flattened to avoid leaking.

4、What is the best way to store POD without using them for a short time? 

It is best to fully charge the mod and take out the cartridge to avoid e-liquid  leakage and Keep out of reach of children.

If your pod start to have burnt taste within short using time

It may be caused by the following：

Too frequent Vaping

Vaping setting is improper

Didn't prime coil before vaping

lack of e-liquid in the core

Defect pod

Suggestions&solutions：

Please try to inhale for several puffs without powering-on while using a new pod or let the pod sits for about 3 mins.

Please use a low wattage setting during the first few puffs.

It is best to fully charge the mod and take out the cartridge to avoid e-liquid  leakage and Keep out of reach of children.

Refilling the e-liquid in an improper way、 Product defect、After repeated oiling and prolonged use、Vaping setting is improper、Sitting for a long time after refilling.Suggestions&solutions for the Vape Leaking From the Air Hole：

1. Before Vaping

Ensure that the pod is not damaged and the rubber stopper is intact without any missing parts.

2. When You Do the Filling:

Slowly inject e-liquid to avoid leakage. Do not completely fill up, leave some space appropriately to prevent the e-liquid from expanding and overflowing due to heat during vaping. After e-liquid injection, ensure that the rubber plug completely blocks the oil injection hole.

3. While Vaping:

Please try to atomize with an appropriate wattage and do not apply excessive suction multiple times in a row.

Besides, please close all the airholes when you do not use it.

Please do not use high-power chargers for charging.

Please do not charge for a long time.

Do not puncture or impact the product battery with sharp objects.

If the battery bulges, heats up, or smokes, please immediately dispose of the device in a fire-resistant area.

If not charged for a long time, it may cause the battery to completely fail.

Please do not disassemble or replace the battery by yourself.

Do not place the device in an area accessible to children.